vmware虚拟机更改配置(vmware虚拟机DPI怎么设置)

The virtual machine is a very powerful tool. We can simulate another independent computer system computer and install the operating system on it. Among them, VMware virtual machine is a commonly used virtual machine. After creating a virtual machine, how to modify the virtual machine hardware configuration? Next, we will introduce the method of editing the virtual machine settings on the computer.
1. To modify the virtual machine configuration, make sure the virtual machine is turned off first;
2. Click "Edit Virtual Machine Settings", and the device below displays the currently set virtual machine configuration information;
3 , First set the memory. If the setting is too much, it will affect the operation of the host system. If the setting is too little, it will affect the operation of the virtual machine system. It depends on the specific situation of the total memory of the computer;
4. The processor is the CPU. Use the default settings, or set according to specific usage if there are other special needs;
5. Set up the hard disk, mainly set the "Disk Utility", depending on personal needs;
6. CD/DVD is the optical drive, if you need to load the ISO To the virtual machine, select "Use ISO image file";
7. Network adapter relationship. Whether the virtual machine system can access the Internet normally after installation, you can use "NAT mode" by default;
8. If the USB controller does not If exists, the virtual machine system cannot use the USB device normally, so it must be turned on;
9. The sound card depends on the required settings, and it exists by default;
10. The printer can be removed if it is not needed;
11. Monitor The function is relatively powerful, you can set the independent display of the virtual machine system separately, and you can turn on 3D graphics acceleration.
The above is an introduction to the method of modifying the hardware configuration of a virtual machine on a computer. Friends in need can follow the above steps.

can be changed. When you create a new virtual machine, you can modify the configuration as long as the power is not turned on.
The specific method is in VM-Virtual Machine Settings.
After creating a virtual machine, you can copy the files to another computer. Click on the other virtual machine to open the virtual machine-related directory to open the copied virtual machine.
You don’t need to install anti-virus software in the virtual machine. You can create a snapshot after creating the virtual machine and restore the snapshot after being infected by a virus.

Today I will introduce to you the specific steps on how to configure the network of the Linux system on the VMware virtual machine.

1. First turn on the computer, find the virtual machine icon on the desktop, double-click to open it

2. As shown in the picture, on the main page that opens, click on the top "Edit" menu

3. In the menu that opens, select the "Virtual Network Editor" option

4 .As shown in the picture, in the pop-up window, select NAT mode at the top

5. Then click the "Change Settings" button in the lower right corner to obtain permission

6. Finally, click "OK" at the bottom to complete the configuration.

1. First find the location of the .VMX file. How to find it, see screenshot:

< /p>

2. It should be noted that all the following operations are performed with the virtual machine turned off:

ethernet0. virtualDev="e1000" <-------Just copy the line of code on the left and add it to the VMX file.

3. After the above operations and saving the VMX file, you can open the virtual machine and enter the system to view.