The steps for partitioning a disk under a virtualbox virtual machine are as follows:
Run the virtual machine software and enter the virtual machine system.
Run the partition software in the virtual machine, select the virtual disk that needs to be partitioned, and then click the "Quick Partition" button.
Select the number of partitions, partition table, size, etc., and then click the "OK" button.
Wait a few seconds for the partitioning to complete.
Note: If there are already partitions and data on the virtual disk, the data and files will be lost after repartitioning. Therefore, you need to back up important data before operating.
The method of installing system partition on a virtual machine is as follows:
1. Search and download "Diskgen" on Baidu, open it and use partition processing on the hard disk.
2. Select partition on the menu and create a new partition, then save and exit. Enter the main interface and select the "PQ Partition" tool. Use PM to format, click to select format to open:
3. Find and select NTFS or FAT32 in the type, any option
4. Select the NTFS format, click OK to return to the main interface of PQ, and set the main boot disk
5. Then click the Execute button , return to the PQ main interface
6. Until the Ghost system can be installed, enter the installation interface again and choose to install the system to the first partition of the hard disk
7. Finally click the OK button. Click to exit and wait for the system to restart, that is, the partition is successful.
This article will introduce the installation steps of win7 virtual machine, including installation method, installation image, system name, virtual hard disk size, partition, etc.
👨💻Select Typical Installation Mode
Select Typical Installation Mode on the Installation Mode panel.
🖼️Select the installation image
Select the installation image and navigate directly to the location where the win7 installation image is downloaded and stored.
🖥️Select win7 system
The system name selected to install is win7, and the 32-bit win7 system is installed. Then take the next step.
💾Set the virtual hard disk size
Set the virtual hard disk size for the win7 system. Because the win7 system itself is relatively large, just use 60G according to the system default. If the hard disk space is insufficient, you can also use more than 30G. can.
🔧Complete the pre-installation preparation tools
Click Finish to complete the pre-installation preparation tools.
🔌Turn on the power of the virtual machine
Turn on the power of the virtual machine and turn on the virtual machine. The operation at this time is basically the same as the computer button. You can press ctrl+alt+enter to maximize the virtual machine, and then operate .
💽Partition the hard disk
Choose to partition the hard disk, because the hard disk is 60G. If not partitioned, there will be only one c drive after installation by default. The hard disk is partitioned. This partition is in the virtual machine. It is done inside, so it will not affect the local system.
📀Clone image installation
Start the clone image installation.
🔄Restart the virtual system
The system is cloned and then automatically restarts.
上一篇:虚拟机如何增加磁盘分区
下一篇:虚拟机增加磁盘并且分区怎么做